supply quality bolts, and nuts

Asia Bolts & Nuts Sdn Bhd Established in 1982 to supply quality bolts, and nuts. Since then, the company has grown rapidly and play an important role in supplying a wide range of bolts, nuts and fasteners to the building and manufacturing industries in Malaysia.

In line with our aggressive planning for further expansion to meet market needs, our Manufacturing Plant:

Asia Bolts & Nuts (MFG) Sdn Bhd was incorporated in 1993, subsequently Anchor Bolts & Nuts Sdn Bhd was formed in Johor Bahru in 1993 to serve the market in the southern region, followed by Asia Bolts & Nuts (Klang) Sdn Bhd a fully computerized subsidiary was incorporated in 1996 to serve the market in the western region on Klang Valley.

Corporate Objectives Corporate Expansion Corporate Mission

Asia Bolts & Nuts (MFG) Sdn.Bhd.
No. 29-5 & 29-7, Jalan Loke Yew, 55200 Kuala Lumpur, Malaysia.
Tel: +6-03-9222-2488 (6 lines) Fax: +6-03-9222-8554
Email: asiabolt @ tm.net.my

We are able to manufacture standard bolts Hot forging up to the following dimension: Diameter up to 64 mm or 2.5 inches Length up to 1 meter In accordance with the international standard such as ISO, Din BS, ASTM, JIS, ANSI and special requirements our Manufacturing Process

Asia Bolts & Nuts Sdn Bhd Established in 1982 to supply quality bolts, and nuts. Since then, the company has grown rapidly and play an important role in supplying a wide range of bolts, nuts and fasteners to the SUS 304, 316 stainless steel bolts, nuts, U-bolts & studs Various types of Customized Anchor bolts, U-bolts, Eye bolts, Plow bolts, Carriage bolts, Couplers & Inserts etc.

Cast-in anchors, Hex socket cap & set screws, F10T High Quality tension control bolting, ASTM A193 Grade B7 stud bolts with A194 2H nuts

Expansion bolts, Chemical anchors & studs, F10T High Strength Friction Grip bolts & nuts, Grade 4.6, 4.8, 5.8, 6.8, 8.8, 10.9 & 12.9 fasteners
ASTM A325 high strength Structural bolts & nuts

Terminology on topics related to nuts and bolts, threaded fasteners and tightening techniques

HOLD AND DRIVE BOLTS - Special bolts that have a tang at the threaded end of the shank.
This tang is gripped by the tightening tool during assembly so that the reaction torque is absorbed whilst the nut is tightened from the same side. Such bolts allow what used to need to be done by two men became a one-man task.

HEAT TIGHTENING
Heat tightening utilises the thermal expansion characteristics of the bolt. The bolt is heated and expands: the nut is indexed (using the angle of turn method) and the system allowed to cool. As the bolt attempts to contract it is constrained longitudinally by the clamped material and a preload results.

Methods of heating include direct flame, sheathed heating coil and carbon resistance elements. The process is slow, especially if the strain in the bolt is to be measured, since the system must return to ambient temperature for each measurement. This is not a widely used method and is generally used only on very large bolts.